“SURFACE DEVIATION”
A basic understanding of all the features on a part. Each select-able point contains surface normal deviation.
3D PART INSPECTION
“PASS / FAIL”
A full view of part features that are out of tolerance to quickly understand and take better corrective action.
“GD&T”
Relationships of dimensions or features are controlled by datum’s, alignment and GD&T callouts
“DIMENSIONAL CHECK”
To satisfy the quality control department its often required to measure discrete dimensions on a drawing and their tolerance.
The output is a fully detailed color coded PDF report, and or an interactive color 3D model that allows the user to pick any points of interest.
We use a full range of measurement tools including structured light and laser 3D measurement devices. 3D measurement devices measure millions of points at a time very accurately. These measured points provide the advantage of visually understanding the part and any defects, and allow for a more accurate and cost effective corrective action and or repair. A practical understanding of the different measurement tools and their strength and weakness.